If your garbage disposal is beginning to act up, or has completely stopped working, there are some simple steps which you can take to identify and fix the problem before calling in an expensive plumber, or replacing the unit. Many times the unit is simply jammed, or has some other fixable problem.

Providing these bathtub repair things are fine there is the chance that the cord running to the disposal has developed a short or a wire has become disconnected. You will need to disassemble the unit to verify all wires remain securely fastened. The last conclusion is that the motor has burned out, in which case you will need to replace the disposal unit.

If you find that the water line repair leak is in the supply line you will need to replace it or simply tighten it. Start by turning the water supply off and then flushing the toilet to get rid of the excess water. Now use the towels to dry the area so that it is easier for you to fix the leak. Use a wrench to loosen the hexagonal nuts on the supply line at the main end as well as the one which goes to the flush tank. Now use the replacement supply line which you have and tighten the bolt at the supply end first. Now adjust the length that you will need for the pipe to reach the flush tank. Once you adjust the length use a knife to cut the extra length and then tighten the hexagonal bolt at the other end.



After you have the stems out you should be able to find the washer on the "inside" end. If it is nicked, torn or brittle it is likely the cause of your drip. Even if it looks brand new, go ahead and replace it. You've already come this far. You can get replacement washers at almost any hardware store. Sometimes you may want to replace the whole stem, especially if the handle end is stripped out. It's best to just take the stem with you to the store and see if you can match it up. Most Do It Yourself stores have replacement stems for many popular brands. If your valve has a center diverter valve to switch the waterfrom the tub spout to the shower head the same process applies. Many times it is easier to replace the diverter stem than to repair it. This really depends on the design of the stem.

Once you have disconnected the tank remove it from your work space. Do a thorough measurement of the remaining pipe for reference when you go to the hardware store. I will be honest with you, you might need to make a few trips back to the store. Once you get the new tank, slide it into place to line up the plumbing.

The water line repair most likely damaged your electrical outlets and lighting fixtures. Have a qualified electrician come in to evaluate and repair the electrical.

To avoid this, make sure your toilets screws are always tight and repair any leaks right away. A new wax ring should also be installed any time the toilet is removed such as if you happen to be replacing an old toilet with a newer model that you liked such as a more modern KOHLER brand. Replacing your toilets wax ring is pretty simple to do and can pretty much be done in less than an hour by the average person.

A large plumbing job, such as re-piping or installing additional fixtures, may require a permit. Check with your city's department of building and safety before asking for estimates, and avoid any plumbers who are reluctant to comply with regulations.